Paper crafts
Card-deck presentation tray
A 66 x 94 mm shallow tray with 22 mm walls, a removable liner and two thumb-access notches.
US Letter · 3 PDF pages · Print PDF
Go to download2 preview images · 3 PDF pages. Open the complete PDF for every page.
Preview of the actual PDF. Open complete PDF
See the page overview
READY TO PRINT
Download this printable.
- Paper
- US Letter
- Pages
- 3
- File
- Print PDF
Free · 43 KB · No account needed
Print the matching paper edition at actual size (100%). Measure the printed 50 mm line before cutting. The screen preview is not a measurement test.
See what is on each page
- Page 1 — base net
- Page 2 — liner
- Page 3 — Assembly instructions
Enter these page numbers in your PDF viewer’s print range. Keep any instructions, matching answers and required project pieces.
Save or prepare these pages
Optional: Studio makes a separate page using this design family and paper size. It does not edit this PDF. Preview every sheet before exporting.
Something wrong with the print?
Check the specific problem, then return to this selected PDF.
Back to the selected file · Report a problem with this printable
Card-deck presentation tray / LETTER
A good fit for your idea?
Choose the exact edition first. Its preview, pieces, paper size and instructions belong together; no physical fit or assembly approval is implied.
Use the notches to reach the stack
The two edge-connected thumb recesses make it easier to lift a light stack without pushing on the tray walls. Remove those scraps before joining the corners.
A decorative tray is not a protective deck case. Keep the stack below the walls and check the actual cards rather than relying on a game-brand label.
Printing, file details and help
About this file
- Instruction pages
- 1
A 66 x 94 mm shallow tray with 22 mm walls, a removable liner and two thumb-access notches.
From file to finished page
- Choose the paper size loaded in your printer and open the matching PDF.
- Print the matching paper edition at actual size (100%). Measure the printed 50 mm line before cutting. The screen preview is not a measurement test.
- Cut the tray net and liner; remove only the two half-round thumb notches from the short wall tops.
- Crease base and corner-tab lines. Glue the tabs inside the adjacent walls while holding the base square.
- Lay the liner over the floor after the corner tabs are secure.
- Test a small stack of approximately 62 x 90 mm scrap cards. Keep the stack below the wall height and lift it using the notches.
- This is a presentation tray, not a specification for a particular card-game brand or protective deck box.
Printing and use notes
The dimensions describe the flat pattern and fold lines, not guaranteed internal capacity.
Physical printing, fit and assembly have not been tested. Make a scrap-paper trial before using special stock.
This is a decorative or organizational paper project, not protective shipping packaging, food-contact material or a load-rated container.
Direct PDF files by design
Card-deck presentation tray (2 files)
- US Letter — print PDF · 3 pages
Page numbers and contents
- Page 1 — base net
- Page 2 — liner
- Page 3 — Assembly instructions
- A4 — print PDF · 3 pages
Page numbers and contents
- Page 1 — base net
- Page 2 — liner
- Page 3 — Assembly instructions